Sound Quality - JBL Radial Handbuch

SYMPTOM

SOUND QUALITY

No sound from JBL Radial
Sound only comes from one
side / channel.
Distortion (static, crackling or
hissing sound)
950-0113-001
POSSIBLE PROBLEM
No power to unit
Incorrect source selection
iPod or audio cable is not
seated properly.
Noise may be caused by
interference from a monitor,
cell phone or other transmit-
ting device.
SOLUTION
Make sure wall power outlet or
power strip has power. Make
sure all switches for outlet /
power strip are on and that all
switches for speaker system
are on.
Ensure that the iPod is
properly docked or that the
auxillary cable is properly con-
nected to an external audio
device.
Turn up the volume.
Check the system with a
known good source.
Connect the aux-in cable to
the headphone jack on your
iPod.
Make sure the iPod or Aux in
cable is seated all the way into
the JBL Radial.
Turn monitor off to see if noise
is eliminated.
Move JBL Radial cables
farther away from monitor.
7
NOTE
Is the LED On?
If the LED is not on, power is
not getting to your JBL Radial.
Try the solutions shown.
If you are using an extension
cable or a third party cable,
make sure it is a stereo
3.5mm male to male cable.
JBL ® Radial Manual