Inhaltsverzeichnis
Werbung
TECHNICAL CUSTOMER SERVICE
Firmware-Update for the LOEWE Mediacenter:
The update is exclusively foreseen for the above mentioned versions of the
The model name can be found on the back of the Mediacenter.
If you use the wrong software for a Loewe set severe damage could happen to the
Therefore any warranty is lost if the wrong software is used.
The update does not change the technical functions of the set.
1.
Transfer the firmware to your PC.
2.
Extract the zip file. A new ISO file is created then.
3.
To burn this file you have to select "burn as IMAGE" within the burning software.
4.
After finalizing the CD insert it to the DVD/CD drive of the Mediacenter as deep as possible
without using force. After that switch on the Mediacenter with the mains switch.
5.
Now use the local on/off button or the one on the remote to start the Mediacenter. The drive will
then load the CD automatically and the red LED of the Mediacenter will flash.
6.
The update process starts automatically. Via the HDMI input on the TV the progress of the update
can be seen.
7.
After the update is finished the CD will be eject automatically, the red LED is on.
8.
Press the on/off button on the remote control Assist. During the boot procedure of the
Mediacenter the red LED will flash. As soon as the boot procedure is finished the LED will turn to
orange constantly.
9.
Now press again the on/off button on the remote control Assist
The LED will turn green now and the Mediacenter is ready for operation.
To check the software version of the set please proceed as follows:
1.
Call the main menu with the Assist remote control.
2.
Select the item "Settings" -> "Utilities" -> "System information ".
3.
Now the software version can be seen on the screen.
4.
The menu can be exit with the "END" button on the remote control.
For successfully creating of an update CD the settings of the burning program as well as
Due to the high number of software versions and burning programs we can not give
any information for the individual settings and use of blank disc manufacturers..
If the disc has not been created using the function "burn as IMAGE"
Please take care during the update process that the Mediacenter is not
disconnect from mains power. This could cause severe damage to the Mediacenter.
"Individual Mediacenter"
"Individual Mediacenter DR+"
"Reference Mediacenter"
LOEWE Mediacenter!
Do only use the software designed for your set!
Mediacenter.
Procedure for updating the Mediacenter:
the selected blank disc has to be considered.
the Mediacenter can not read it.
Hint:
III - 2
Loewe Opta GmbH
96317 Kronach, Industriestr. 11
96305 Kronach, Postfach 15 54
Telefon (0 92 61) 99-0
Telefax (0 92 61) 99-730
e-mail:
loewe@loewe.de
www.loewe.de
Werbung
Inhaltsverzeichnis
