Sunshield - CamOnetec FCHD79 Stratos Bedienungsanleitung

Charging the internal LiPo- Battery
To charge the internal battery, the separately available Power Adaptor is required
(HS1126; not included).
Connect the Power Adaptor to a power socket and then into the „DC IN" plug of your screen.
During charging, the right LED (next to the Power Button) flashes red. The LED shuts off as soon as
charging is finished.
You may also charge the internal battery through an external LiPo battery.
This battery should contain at least 7.4 Volt and 2600mAH.
Please note that damages resulting from improper use or connection of an unsuitable power source
are not covered under warranty
technics and potential risks involved. Make sure that the power source used has sufficient capacity!
The battery is replaceable. To remove it, pull down the locker that is located underneath the battery
(backside of the screen) and then lift up the battery block by using the notch that is located next to the
locker. To re-connect the battery, insert it by holding it towars the golden contacts at first.

Sunshield

Add the sunshield to use the screen in bright light without limitations.
Simply fix it around the screen.
The tripod thread is located on the bottom of the screen. This way you are able to attach the screen on
a regular tripod screw.
www.CamOneTec.com
.
Carry out changing operations carefully and well aware of the
15