Airland DH60 Bedienungsanleitung Seite 10

3. Selection of protective device and cable specification
Leakage Rated current
circuit
Rated residual
breaker
Operating current mA
Fuse A
Power cable (mm
Signal line (mm
Note: The data above is suitable for power lines shorter than 10 meters. For
those longer than 10 meters, the wire diameters must be increased. The
maximum length of signal line is 50 meters.
4. Installation instructions and requirements
Dehumidifier must be installed by professional technicians and you as users
cannot do the installation by yourselves, in case that it may cause harm to
others and yourself or damage the machine.
A. Installation of machine
1) Dehumidifier should be installed in a place with good ventilation.
2) The bolt (M 12) must be used to fix the machine body during the
installation. The machine can be fixed on the concrete foundation or
support, with the concrete foundation being firm and the support
being of great strength and anti-rust treatment.
3) Please notice that there will be condensate water coming out from
classis during the operation. Connect the drain port to the drainage
hole in classis and link the drainpipe to enable the smooth
flowing-out of condensate water.
B. Electrical wiring installation
1) Use the special power supply and the supply voltage should be in
Type
A
2
)
2
)
DH60
20
30
20
3×2.5
3×0.5
7
DH90 DH120
30 32
30 30
30 32
3×4 3×4
3×0.5 3×0.5