Transponder; Time Setting - Dyon COBRA Bedienungsanleitung

Blind Scan
First scan the band to get the transponders which can be locked. After gathering all Transponders, Scan
the transponders one by one to get the programs.
5.3.2

Transponder

Press GOTO to switch the list to show transponders of the focused satellite. Also you can press GOTO to
switch back to satellites' list.
Add transponder:
Press RED to add a new transponder. It can't save an existing TP under the same satellite.
Edit transponder:
Press GREEN to edit the focused transponder. It can't save an existing TP under the same satellite.
Delete transponder: Press YELLOW to delete the focused transponder. Press OK to confirm.
Single Transponder Scan:
Press BLUE to pop the menu of scanning setting. After configuring the settings, Press OK to start
scanning.
Multi-Transponder Scan:
Press OK to select transponders with the mark" ",then press BLUE to pop the menu of scanning setting.
After Configuring the settings, press OK to start multi-transponder scanning.
5.4

Time Setting

To access the Menu, press MENU then select [Time]. The Menu
provides options to adjust the time settings. Press
an option and press /
the menu.
(1)Time Auto: Update time with the stream time, or NOT.
(2)Time Zone: Select the Time Zone Offset.
(3)Date: Show and set the system date.
(4)Time: Show and set the system time.
(5)Auto Standby: If this setting is off, this function does not work. If
this setting is not off, a message will pop up after
your preferred time to inform you, that the device
will go in to standby mode. This
n o any operat
p eriod at 0-12 hours. Standard setting is off.
Press STANDBY button to exit standby/auto-off mode.
DYON COBRA
to adjust the settings. Press EXIT to exit
message will appear under
ion. Auto-off function can
/ to select
be set in a time
13