Operating Instructions; Troubleshooting; Specifications - AKG CA810 Bedienungsanleitung

5. Operating Instructions

Refer to the Installation section of this manual for proper connection of the CA810 to other equip­
ment and speakers. Remember that the CA810 expects a loudspeaker load without a matching
transformer at the speaker. Adjust the Channel Level controls until a comfortable sound level is
reached.

6. Troubleshooting

SYMPTOM
1) No sound from system

7. Specifications

Line Input
Type:
Impedance:
Input Level for Rated Output:
Output Power:
Output impedance:
Maximum System Gain
Line Input to Speaker Out:
Signal-to-Noise Ratio:
System THD:
System IMD:
Slew Rate:
Power Consumption:
Weight:
Dimensions:
POSSIBLE CAUSE
1) Channel Level control not turned up
2) Channel input incorrectly wired
3) Power switched off
4) Fuse may be blown
Electronically balanced and RF filtered
20k Ohms, Balanced or Unbalanced
-2dBu (615mVRMS) at maximum level
+15dBu (4.36VRMS) at mid level
10 Watts into 4 Ohms, 6 Watts into 8 Ohms
20 Watts into 8 Ohms with bridged mono configuration
4 Ohms minimum
20dB (x10)
88dB relative to 10W at 4 Ohms
Less than 0.1%, 20Hz to 20kHz (10W into 4 Ohms)
Less than 0.1%, 60Hz/7kHz (10W into 4 Ohms)
12V/uS
300 Watts max at 120VAC
8 lbs, 9 ozs
19" wide x 1.3/4" high x 8 1/4" deep
Specifications subject to change without notice.
14
CA810