Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Turn on the unit by Off/function selector (25), the POWER LED indicator (2) will light up.
3.
Battery installation
1. Open the battery door at the rear side of the unit to install the battery.
2. Follow the engraved marking in the compartment to install 8pcs "D" size / UM1 battery with the correct
direction to the battery compartment (30). Then cover the battery door.
Manual tuning
1. Set the Off/function selector (25) to select TUNER position.
2. Select the desired band by Band switch (26).
3. Tune to the required station by turning the tuning knob (8).
4. Press volume button (27) to the adjust volume level.
FM-stereo reception
The FM-stereo LED indicator (5) will light up when FM stereo program is receiving.
Hints for best reception:-
FM : the receiver has a built-in FM wire antenna hanging at the rear cabinet. This wire should be totally
-
unraveled and extended for best reception.
Am : the receiver has a built-in am bar antenna. If am reception is weak, slightly rotate or re-positioning
-
of the unit will usually improve the am reception.
Playback of MP3 song via USB storage media or memory card
Connecting
The system is able to decode and playback all MP3 file which stored in the memory media with USB
connecting port or SD/MMC memory card.
1. Plug-in the USB plug with the face up & make sure it going into completely or insert the memory card in
the direction of the arrow as shown in the label on the underside of the memory card slot cover. Insert
straight without bending.
2. Set Function selector (25) at USB/SD position, system default set in USB mode, press source button (22)
to select between " USB or SD " mode.
Connecting the USB upside down or backwards could damage the audio system or the
storage media (USB thumb drive/SD/MMC card). Check to be sure the direction is correct
before connection.
3. The system will start reading the storage media automatically after connecting, and LCD display (3) will
show the total number of MP3 files being detected and then start to playback automatically.

Listening to radio

E-1

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis