Installation; Specifications - Elkron IT-USB Handbuch

DESCRIPTION
A PC USB interface is an accessory for connecting the PC to the control unit through the USB port (similarly
with the TTL/RS232 interface that is connected to the RS232 port), for programming by means of the FAST
LINK software.
CONFIGURATION
In order to correctly use the interface, the dip-switches shall be set as indicated in the table below:
Switch Function
Monitor LED
1
Selecting the type of control
2
unit
-
3
-
4

INSTALLATION

•
Fit the cable running from the IT-USB interface (WITHOUT CONNECTING THE LATTER TO THE
CONTROL UNIT) into the computer USB port. Wait for Windows
peripheral unit. Select, when the driver requests so, the USB_FDTI
release 3.00 and following), then complete the installation.
•
Warning! Make sure that the address assigned by Windows
range of COM1 to COM4 (see next paragraph).
•
Then fit the interface comb-shaped connector onto the control unit (see figure).
•
Remove the interface after use.
SETTING THE COMMUNICATION PORT ADDRESS
®
Windows 98:
Path: File manager
Control panel
Select Port settings, then click on Advanced. Then select a free COM port number (1 to 4) from the drop-
down menu.
®
Windows 2000/XP:
Path: File manager
Control panel
Select Port settings, then click on Advanced. Then select a free COM port number (1 to 4) from the drop-
down menu.
FAST LINK:
Select Actions
Archives
4) from the drop-down menu.

SPECIFICATIONS

Rated supply voltage Vdc – from the PC................................................................. 5 V―
Rated absorption Icc – from the PC ........................................................................ 25 mA
Standard .................................................................................................................. USB 1.1 - 2.0 compatible
Operating temperature............................................................................................. 0 ÷ 45°C
Warehousing temperature ....................................................................................... –20 ÷ 70°C
Description
When set to ON, it makes the LEDs to blink during
communication between the PC and the control unit
OFF = Use with wireless control unit WL30
ON = Use with control units MP106, MP110, MP120
Always leave set to OFF
Always leave set to OFF
System Peripheral control
System Hardware
Configuration Modem
®
®
folder from the FAST LINK CD (only
®
to the USB port falls within the
Ports
Peripheral control
Bus configuration: select a COM port number (1 to
3
to detect the presence of the
Properties
Ports
GB
IT-USB