Werbung
Settings in service mode menu:
Menu-table 3:
mode analog channel 2
display values
ext.scart
waterglass/panorama
low power standby
further parameters:
format
AGC
vertical amplitude
vertical position
S-correction
vertical symmetry
vertical bow
vertical angle
horizontal position
horizontal amplitude
cushion
trapeze
upper corner
th
upper corner 6
lower corner
th
lower corner 6
blanking phase left
blanking phase right
chroma delay
luma delay PAL
luma delay SECAM
luma delay NTSC
DVCO
G2
cut off
OFF / AUTO / SENSOR / KEYS for TV sets without panel keys chose
SENSOR, with panel keys: AUTO
ON / OFF
OSD: numbers or bars to show the actual value
set to 1 (for actual scart module)
ON / OFF
activate / deactivate special picture effects (Effect 1+2)
ON / OFF
option depending on chassis-version
select the right picture format for geometry alignment
see AGC alignment
adjust vertical image height.
adjust vertical image position.
adjust vertical linearity.
adjust vertical symmetry (adjust S-correction against vertical symme-
try)
adjust straightening of vertical lines.
adjust inclination of vertical lines
adjust horizontal image position.
adjust image width.
adjust Pincushion (East/West-cushion).
Set the vertical lines parallel.
adjust vertical lines in the upper corners.
adjust vertical lines in the very upper corners.
adjust vertical lines in the lower corners.
adjust vertical lines in the very lower corners.
to adjust horizontal blanking phase on the left picture side (default
value 170)
to adjust horizontal blanking phase on the right picture side (default
value 1210)
to adjust chroma to luma signal (just one value for all signals and
sources).
to adjust luma to chroma signal on PAL picture (Luma delay PAL on
tuner and scart are independent, adjust both of them).
to adjust luma to chroma signal on SECAM picture (Luma delay SE-
CAM on tuner and scart are independent, adjust both of them).
to adjust luma to chroma signal on NTSC picture (just available on
scart input).
The auxiliary colour carrier frequency automatically adjusts to its refer-
ence value. (read only value)
see chapter G2 adjustment
see chapter cut off / white drive
13
Werbung
