Info; Standalone Mode - JBJ Lighting A8 Bedienungsanleitung

COOLING MODE
The A8 offers three different modes for fan opperation. The default setting STANDARD will
suit most applications. Switch to SILENT to reduce the speed of the fans to a minimum.
This mode is to be used only a well ventilated rooms with low ambient temperature, with
reduced light output or if the fixture is only required occasionally. The HI POWER mode is
designed to be used in areas with higher air temperature or for fixed installtions. The fans
start to run faster with more airflow which produces more noise.
There is in no mode danger for the lifetime of the A8. If the temperature rise to
much the fixture switches off automatically.
WLJB DMX HOLD
The behavior of the A8 incase the wireless DMX connection is interrupted can be set to:
1. DMX Hold - A8 freezes on the last received DMX value.
2. Fade out - A8 fades out after 5 seconds.
When DMX signal is back the A8 first turn to his new position and fades in.

4.5 INFO

The menu informs about the current software/firmware version. The non-resettable
TOT OPERATE TIME counter displays total hours of use since the A8 was manufactured.
Temperature readouts from the display panel (TEMP BASE LCD) and power supply unit
(TEMP BASE PS) in the base as well as the driver (TEMP HEAD DRV) and LED PCB
(TEMP HEAD LED) in the head are available. In each case, you can view the current
temperature and the maximum temperature reached since the readout was last reset
individually.

4.6 Standalone mode

A sequence, up to 20 steps, consisting of preprogrammed cues can be recalled by means
of the STANDALONE MODE. The sequence will run as a loop. Cues can be entered in two
different ways. The first way is to program every feature by means of the key of the units
onboard control panel. The second way is to program the cues by means of a connected
DMX control console and to store them in the fixture.
IMPORTANT!
The functions MODIFY, RUN and REMOTE can be accessed only by pressing a combi-
nation of keys and not just by pressing "ENTER". Before activating the functions make
sure that there is just one DMX-transmitter in the DMX-line (e.g. one controle console or
one master fixture). A number of DMX-transmitters can damage the DMX driver of the
fixtures. To enter the functions press "ENTER" (keep it down) and press "ESC" in addition.
Programming the standalone sequence:
Enter the menu STANDALONE, EDIT.
STEP NR 01/01 will be displayed.
Enter the MODIFY menu to get access to the fixtures functions. Recall the functions and
enter DMX values.
Enter FADE TIME (during which the effects will move to the programmed position) Enter
NEXT TIME which will be the duration of the step.
Add a new step with INSERT. The DMX values of the last step will be automatically copied
to the new step.
28