Werbung
EPG recordings can be stored in SAT mode and in Aerial mode. The Exit key switches off the
display.
Standby recording begins
10 seconds before the actual recording the blue standby light switches off. This is not an error;
after about 10 seconds the standby LED begins to blink in quick succession.
If there is no break between 2 recordings or if another tuner is switched to, the display goes
off for about 10 seconds.
While this is happening, the recording is being prepared for the stick.
Recording during a TV programme
10 seconds before the planned recording a message appears in which a time display counts
backwards and which can be confirmed with Yes or No.
(If you do not want to make a recording, confirm No using the
The device then prepares the recording (display) and starts the recording right on time.
Preparing Record
40
key and Enter.)
ENGLISH
If the timer was set in Aerial (DVB-T2), the televison switches from Satellite to Aerial with the
notifications 10sec and Preparing Recording.
If the film has been recorded, the televison switches back.
Recordings on alphatronics devices with built-in memory (Variant H in the SL Line)
The built-in read-only memory has a capacity of 32GB. This is sufficient for about 5h HD
and about 10h for SD recordings. If longer recording times are necessary, you can switch to
external mobile hard discs. Please ask for hard disks for TV devices in stores. These consume
less power than PC hard disks.
SL Line Individual Variant H
Recording on external storage media (hard disk, USB stick)
Menu: Configuration – PVR system
Select top line and
key changes to D:
Checking the timer list
Because the EPG programming has been tried and tested, you can only double check the timer
list via the EPG page.
The yellow key (schedule) on the remote control calls up the timer list in which pre-stored
programmes are displayed.
With the red key (Delete) individual types of programming can be deleted.
41
Werbung
