Hardware Overview - TerraTec CONNECT N3 Schnellstartanleitung

CONNECT N3

Hardware Overview

Device on air
LAN activity light Power light
WLAN activity light WPS activity indicator
On / off switch WPS switch
On / off switch: Hold down the button for 2 seconds to turn power on / off.
LAN activity: Lights up when network cable is connected, flashes during data transfer.
WLAN activity: Off when WLAN is disabled, blinks when wireless LAN is on and
active.
Power light: Off when not connected to the power supply. Red in standby, blue when
turned on.
Device on air: Lights up when a station is transmitted to the client.
WPS activity indicator: Flashing when the device is in WPS mode.
WPS switch: Press the button for about 2 seconds to make contact with a other
wireless device.
Power Connector
Reset Button Ethernet (Network) Connector
Antenna Connection
Reset Button: Hold for 5 seconds to set the device back to factory default.
Ethernet Connector: Network socket which connects the N3 to your network (router).
Power Connector: Socket for the power supply. (12 Volt / 2 Ampere).
Antenna Connection: Connector for the antenna cable that comes from your satellite
dish.
16