Usb Flash Drive Operating Instructions - ACP jet 5192 Bedienungsanleitung

USB Flash Drive Operating Instructions

TURN PREHEAT OFF
To program the oven using the USB Flash Drive:
Oven must be in Standby mode (Preheat must be OFF)
Note: A standard USB flash drive is compatible with oven.
1. Remove protective cover from bottom of vertical keypad.
2. Insert the USB Flash Drive into the slot located below the vertical keypad.
3. Open the oven door.
4. Press and hold the 5 pad until USb appears in the display.
5. To transfer programming FROM the USB flash drive to the oven, press the 1 pad. "USb TO OVEN"
will appear in display.
OR
To transfer programming TO the USB flash drive from the oven, press the 2 pad. "OVEN TO USb" will
appear in display.
6. Press START pad
7. Oven displays "LOADING" in the display for approximately 10 seconds.
8. When the transfer is complete the display will beep and display "Done" and number of programs
saved.
9. Press any pad to clear the display or shut the door and the display will read "READY".
Error Codes:
1. NO USb: Remove flash drive from USB and reinsert flash drive into USB and retry.
2. RESET OVEN: Unplug oven from outlet and plug in oven and retry transfer.
, on vertical keypad to begin transfer.
PROGRAM SAVE
USB Port
12