Check Before Use - Diamond3 MS60 LITE Bedienungsanleitung

2. CHECK BEFORE USE

1. EXTENSION CORD
220 V
Max.
Nominal
Length
Cross Section
0.75 mm 2 40 m
2
1,5 mm 60 m
2,5 mm 2 100 m
2. WORKING AREA
Inspect the working area according to the safety instrutions in this manual.
3. POWER SUPPLY
Make sure the power supply corresponds with that of the machine.
4. SWITCH
Avoid accidental starting of the machine by making sure that the machine is turned off
before plugging it in.
Press and release the main switch before use to make sure it functions properly.
5. BLADE GUARD
The blade guard is designed to protect you from any parts that may
come loose from the grinding wheel or working material. Always use
the blade guard.
Always use the blade guard and set it to an angle that provides maximum protection.
6. INSPECTION OF THE CUTTING BLADE
Before use always check wether the cutting blade is mounted correctly. For the
proper mounting procedures see chapter 5.
7. TRIAL RUN
Make sure the machine is working properly before use by making a trial run.
Be aware of bystanders.
An extension cord may be used when the power source is
located at a distance. Use an extension cord with proper
length and thickness in order to avoid a reduction of volt-
age. Use the shortest extension cord available.
Replace damaged extension cords immediately.
35
GB