Cleaning And Maintenance; Technical Data; Troubleshooting - Valueline VLS-DVBT2-FTA1 Bedienungsanleitung

Cleaning and maintenance

Warning!
• Before cleaning or maintenance, switch off the device,
remove the mains plug from the wall socket and wait
until the device has cooled down.
• Do not use cleaning solvents or abrasives.
• Do not clean the inside of the device.
• Do not attempt to repair the device. If the device does
not operate correctly, replace it with a new device.
• Clean the outside of the device using a soft, damp
cloth. Thoroughly dry the outside of the device with a
clean, dry cloth.

Troubleshooting

If you cannot solve the problem, contact your dealer.
Problem
No sound.
No picture.
The image stops or looks like mosaic.
The screen shows the message "No
Signal".
The remote control does not work.
Possible cause
No or incorrect audio cable connection.
The sound is muted.
The device plays an incorrect sound track.
The mains plug is not inserted into the wall socket.
The device is switched off.
The signal is too weak.
The antenna cable is not connected.
Incorrect settings.
The batteries are low.
The remote control is not pointing to the device.
8 8

Technical data

Input voltage
Frequency
Electrical power
Tuner
Input frequency
RF input level
IF bandwidth
Modulation
File format
Audio
Video
Solution
Connect the audio cable correctly.
Unmute the sound.
Change the sound track.
Insert the mains plug into the wall socket.
Switch on the device.
Strengthen the signal.
Connect the antenna cable.
Change the settings.
Replace the batteries.
Point the remote control to the device.
Make sure that nothing blocks the front panel.
English
100 - 240 V AC
50 - 60 Hz
8 W
170-230 MHz / 470-860 MHz
-25 ~ -78 dBm
7 MHz / 8MHz
QPSK / 16 QAM / 64 QAM
MPEG-1
MPEG-2 / MPEG-4