Microlab X13 Gebrauchsanleitung Seite 3

Function Instruction
*Front View of the Subwoofer
MULTIMEDIA SPEAKER SYSTEM
STANDBY INPUT-SEL TREBLE/BASS VOLUME VOLUME
Input select
Volume-
STANDBY INPUT-SEL TREBLE/BASS VOLUME VOLUME
Standby Treble/Bass Volume+
*Back View of the Subwoofer
7
1.PC INPUT: 3.5mm stereo audio input jack
2.AUX INPUT: 2RCA input jacks
AUDIO INPUT
1
3.AUDIO OUTPUT: 2.1 channel (2 RCA) audio output
PC
AUX 2
R L
4.POWER CORD
5.FUSE
AUDIO OUTPUT
R L
3
6.
7.
FUSE
T630mAL250V AC IN
ON
OFF
6 5 4
*Front View of
Remote control
1.ST-BY:Standby
1 2 3
2.AUX: press to select AUX Input mode
3.SLEEP:p ress to activate the leep
t imer function and the durationw hich
ST-BY SLEEP
the receiver turn offautomatically
PC AUX RESET
4 5
4.PC: press to select PC Input mode
INPUT
5. Reset: press this key to make the
6 7
TREBLE BASS
system come back to the start
9
8
situation
MASTER
6. TREBLE+/-:p ress to adjust the
VOL
BAL L R BAL
volume level of all treble
VOL
time
MASTER
10
7 .BASS +/-:p ress to adjust the bass
volume level
8.MASTER VOL +/ -:press to adjust the
volume level of all speakers at the
same time
ress to mute the sound
9.Mute: p
10.BAL R/L: press to adjust the balance
of s atellite speakers
jacks
POWER: Press the switch ON or OFF
Heat sink
3
System Connection
s
treble
at the same
R
*Please note the correct placement of speaker is shown in the above picture.
System Connection:
1. Connect the satellite speaker cables into the
of the subwoofer, then put the left channel satellite speaker on the left and the right satellite on
the right.
2. Connecting the speakers to the
1) please use the audio cable(3.5mm-2RCA). Connect RCA plugs of the audio cable into the L&R
AUX input jacks on the back of the subwoofer, the other end into the output jack on the stereo
audio source.
2) please use the audio cable(3.5mm-2RCA). Connect 3.5mm stereo plug of the audio cable into
the PC input jack on the back of the subwoofer, the other end into the L&R output jacks on the
audio source.
3) Please use the audio cable(3.5mm-3.5mm). Connect one end of the audio cable to the PC input
jack on the back of the subwoofer, then the other end to the output jack on the stereo audio source,
remarks: the audio cable(3.5mm-3.5mm) set is only for demonstration
3. Check the connection and make sure every cable is correctly connected, then connect power plug
to the right AC outlet. The shape of the plug and power outlet depends on the country of use.
* Statement indicating that the socket-outlet shall be installed near the equipment and shall be easily
accessible.
* The highest environmental temperature suitable for this product is 40 C.
Connect the plugs to audio source
SUBWOOFER
AUDIO INPUT
PC
AUX
R L
AUDIO OUTPUT
R L
FUSE
T630mAL250V AC IN
ON
OFF
corresponding L & R audio output jacks on the back
audio source.
o
4
L