EuroLite MD-3010 Bedienungsanleitung Seite 15

Attachment
The rotary motor should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the mirrorball. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and.or
damage to property.
The motor must only be installed in an absolutely horizontal position at a vibration-free, oscilation-free and
fire-resistant location. By using a water-level, make sure that the motor is installed absolutely horizontally
and that the motor axle points exactly to the bottom.
The motor and the mirrorball have to be installed out of the reach of people.
If the motor shall be lowered from the ceiling or high joists, professional trussing systems have to be used.
The motor must never be fixed swinging freely in the room.
Caution: Mirrorballs may cause severe injuries when crashing down! If you have doubts concerning the
safety of a possible installation, do NOT install the motor!
Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's load (e.g. maximum load 3 kg - point load 30 kg).
The mirrorball motor must always be installed via all fixation holes. Do only use appropriate screws and
make sure that the srews are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1: The fixation holes are located on the baseplate.
Step 2: Hold the baseplate onto the location where the device is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Hold the baseplate in the desired position and tighten it.
The installation material must never include abrading material e. g. steel cables in order to avoid
The length of the chain must never exceed 100 cm.
Install the mirrorball chain with the screw-on chain link at the installation eyelet of the mirrorball and tighten
the fixation screw.
Insert the fourth chain link of the mirrorball chain with the mirrorball in the screw-on chain link and tighten the
fixation screw.
For overhead use, always install a safety chain on the mirrorball that can hold at least 12 times the weight of
the installation. The safety chain must be slightly longer than the mirrorball chain so that the safety chain will
always be tension-free. Pull the safety chain through the safety eyelet of the mirrorball and in the safety
eyelet of the motor.
There must never hang a mirrorball or other load at the safety eyelet. Loads must only be hanged at the
quick link of the installation eyelet at the motor axle. If a mirrorball hangs for any reason at the safety eyelet,
material wearing.
15/31 50301510_V_1_2