Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Application
The RAICO work table 298 101 is designed
exclusively
for
multifunction punch press 2 (298 100).
Fork lift transport openings are provided in the
base.
For reasons of work safety and stability the
work table must, after transporting to its
location, be securely fixed to the floor using the
hexagon headed screws and brass anchor
plugs provided.
On the side of the work table there is a hook for
hanging a compressed air gun as well as a
bracket for holding a can of lubricant (e.g. WD
40).
There are two shelves in the work table for
storing RAICO interchangeable tools.
Mounting the RAICO multifunction punch
press 2 (298 100)
On the top of the RAICO work table there are
four threaded holes provided for fixing down the
pneumatic press from the RAICO multifunction
punch press 2.
The pneumatic press is fastened to the
threaded holes in the RAICO work table by
means of four M10x40 socket headed screws.
In so doing, take note that the Ø40 mm rubber
washers provided with the RAICO multifunction
punch press 2 are placed between the
pneumatic press and the RAICO work table.
The seating slot on the pneumatic press is to
be set up pointing to the front in accordance
with the adjacent illustration.
mounting
the
RAICO
Mounting instructions
Spare parts
Spare parts can be ordered direct from RAICO
using the article number stamped on the
component or given in the spare parts
drawings.
All spare parts used must comply with the
manufacturer's
requirements.
It will help save time and money if you state the
order number of the defective component when
placing an order.
Ordering address
RAICO Bautechnik GmbH
Gewerbegebiet Nord 2
87772 Pfaffenhausen
Tel:
+49 (0)82685 911 0
Fax:
+49 (0)82685 911 100
info@raico.de
www.raico.de
Version 1.1
Work table
298 101
specified
technical
Werbung
