Assembly Instructions - Yvan Bea YB38T Bedienungsanleitung

Using the machine on steep slopes is dangerous!

Assembly instructions

1. Figure 1 shows the contents of the kit:
a. Blades.
b. Depth skid with transport wheels.
c. Tiller with cables.
d. Upper handlebar
e. User manual and mounting bolts.
f. Lower handlebars, right and left.
2. Fit the two lower handles using the accompanying bolt. Make sure that the handles
are turned the right way.
Fit handle (a.) on the right and handle (b.) on the left.
Fig 2, 3.
3. Fit the upper handle using the accompanying bolt set.
Pay attention to the arrows on the plastic brackets. They must be aligned when
mounting.
Fig 4, 5.
4. Mount the throttle cable (a.) and clutch cable (b.) as shown in the figure.
Fig 4
5. Apply grease to the transmission, as described in this manual.
Fig 6.
6. Mount blades, depth skid and transport wheels using the accompanying cotter
bolts and pins
Fig 7, 8.
Maintenance
The gearbox is permanently lubricated at the factory, never open the gearbox.
If necessary to add grease do as follows:
Remove the spark plug cover on the engine.
-
Place the pack of grease in a bucket of warm water. This will make the consistency
-
thinner, so it is easier to add to the gear. Avoid cutting off too much of the tip on the
pack. It is important that the tip is as pointed as possible.
Add grease until it comes out of the filler hole when the gearbox is in horizontal
-
position.
Operate the clutch lever and pull the starter cord 3 times to distribute the grease
-
around the gear.
Then add more grease until the gear is full.
-
- Fit and tighten the screw.
Fit the spark plug cover on the engine.
-
Figure 6
Check grease level and add grease to the gear for every 5 operating hours
Grease is not included!
"Be careful of rotating blades"
Only use the machine in areas where it can be
operated safely
9