Omnitronic 60004120 Bedienungsanleitung Seite 2

Speaker Stand
For your own safety, please read this leaflet carefully
before you initially start-up. You can find the latest
update online.
Applications
This stand is designed for installing speaker systems
with a suitable flange. It is designed for professional
use, e.g. on stages, in discotheques, theaters etc.
Safety Instructions
1
Unpack the product. Before you initially start-up,
please make sure that there is no damage caused
by transportation. Should there be any, consult your
dealer and do not use the product.
2
This product has left our premises in absolutely
perfect condition. In order to maintain this condition
and to ensure a safe operation, it is absolutely
necessary for the user to follow the safety
instructions and warning notes written in this user
manual. Damages caused by the disregard of this
user manual are not subject to warranty. The dealer
will not accept liability for any resulting defects or
problems.
3
If the product will be operated in any way different to
the one described in this manual, it may suffer
damages and the guarantee becomes void. Please
consider that unauthorized modifications on the
adapter are forbidden due to safety reasons.
4
Do not exceed the carrying capacity of the stand.
5
Do not exceed the maximum extension height.
6
The load has to be installed in a balanced way.
7
Stands may cause severe injuries when crashing!
Only install on a plane area with a maximum
inclination angle of 5°. An unintended movement of
the load has to be avoided.
8
When using stands under the influence of horizontal
forces, e.g. through wind, the standing safety can be
impaired. This is why additional safety measures
like attaching ballast weights have to be taken. If
inclined tension cables or prolonged outriggers are
used, the area of danger has to be marked or even
be blocked.
9
Before lifting or lowering the telescopic tube, always
block a safety area around the stand. This safety
area must have a diameter of 1.5 times the
maximum height.
10
The installer is responsible for adhering to the
carrying capacity given by the manufacturer, the
safety requirements and the qualification of possible
co-workers.
11
Before taking into operation, check upon possible
damages. If defective, the stand must not be taken
into operation.
Installation
(1) Holes
(2) Telescopic tube
(3) Fixation screws
(4) Locking pin
(5) Stand tube
(6) Legs
1
Loosen the fixation screw of the legs. Pull out the
legs until the cross struts stand at a 45° angle to the
legs. Tighten the fixation screws of the legs.
2
Attach a speaker system with an appropriate flange
on the top end of the stand and loosen the fixation
screw and remove the locking pint at the telescopic
tube. As soon as you have reached the desired
height, tighten the fixation screw and insert the
locking pin.
3
For disassembly, first loosen the fixation screw,
remove the locking pin and pull in the telescopic
tube completely. Then tighten the fixation screw,
insert the locking pin and remove the speaker
system.
Technical Specifications
Max. carrying capacity:
Max. load (DIN15560):
Minimum height:
Maximum height:
Material:
Weight:
Subject to change.
D00103577, version 4.0, publ. 28/10/2016
© Omnitronic. All rights reserved.
No. 60004120
30 kg
18 kg
1.4 m
2.3 m
aluminum
3 kg