B+B RT817 CE Bedienungsanleitung Seite 2

OPERATION MANUAL
Hygro-Thermometer with outdoor sensor
RT817 CE
Description Description Description
Description
Technical data
Hygro-thermometer RT817 CE
Measuring range Inside: 0...+50 °C, 20 ... 99 % RH
Outside: -50...+70 °C
Accuracy Temperature: ± 1 °C,
humidity ± 3 % RH at 25 °C
Time: 3 sec/day
Resolution
0,1 °C, 1 % RH, 1 min
Measuring rate 10 sec
Display dimensions 79 x 66 mm
Thermometer
98 x 110 x 21 mm
dimensions
Outdoor sensor Wire length 3 m
Battery 1,5 V Type AAA
Alarm duration 12 min
CE-Conformance 2004/108/EG
EMV-noise emission EN 61000-6-3:2011
EMV-noise withstanding EN 61000-6-1:2007
Ordering number 0560 0064
Technical changes reserved
0141 0315-144 23.08.2016
B+B Thermo-Technik GmbH | Heinrich-Hertz-Straße 4 | D-78166 Donaueschingen
Fon +49 771 83160 | Fax +49 771 831650 | info@bb-sensors.com | bb-sensors.com
Features
• frost alarm, outside temprature probe with braket
• Jumbo-Display for: Temperature indoor/ outdoor, humidity, time
• MIN/ MAX-temperature memory
• Daily Reset function for MIN/MAX-memory
• Alarm clock, alarm snooze
• Foldaway stand, mounting keyhole
• °C/°F selectable
• 12 or 24 hour format selectable
Operation
Use sensor holder to fix outdoor sensor at desired outdoor space. Plug
outdoor sensor into unit. Install battery with correct polarity positioning. The
unit will perform a self-test and display readings normally after 5 seconds.
Place unit at the place away from direct sunlight, rain or extreme heat. Peel
off display protective sheet.
Time setting
Press and hold SET-button until "SET" icon appears, then release. Press
"MAX/MIN"button to set hour. Press SET once. Press MAX/MIN button to
set minute. Press SET again to finish.
Clock alarm setting
Press SET once and "Alm" icon will appear. Repeat time setting steps to
set alarm time.
Maximum/Minimum reading memory
Press MAX/MIN button to display maximum measured value, press the
button once more to display minimum measured value, press the button
again to return to normal display. Press and hold MIN/MAX button until two
bars "--" are displayed then release to reset memory.
Outdoor temperature display
Press OUT button to display outdoor temperature. Press the button again
to display normally.
Frost alarm
Press ALERT to switch on ice point alert function and alarm will sound
when outdoor temperature is below 0 °C.
1 / 1