Fujitsu KVM series2-Adapter Bedienungsanleitung Seite 2

The following instructions will help you
install and use your KVM series2-
Adapters easily.
Should you require further assistance, please
consult your installer/user guide.
About the KVM series2-Adapter module
The KVM series2-Adapter module is one part of the
KVM series2 system and is designed to drastically
reduce cable bulk. Choose between PS/2, USB and Sun
cable options. Use your KVM series2-Adapter module
to convert keyboard, monitor and mouse signals from a
server through a single CAT 5 cable (up to 98.5 feet or 30
meters) to your unit.
The KVM series2-Adapter module draws its power from
the server and has Keep Alive functionality that will keep
your server working properly with or without connectivity
to the KVM series2 unit.
Troubleshooting tip
Make sure your server is powered up before operating
your KVM series2 system. If a server is unavailable
through OSCAR, doublecheck your cable connections or
test another KVM series2-Adapter module in its place.
Optimal screen resolution
For an optimal screen resolution of 1280x1024, limit
the cable length between the switch and the attached
servers to 15 meters. Cable lengths greater than 15
meters will limit screen resolution.
Maximum 1280x1024 1024x768
Cable Length
@ 85 Hz @ 85 Hz
3 meters (9.2 feet) Supported Supported
15 meters (49 feet) Supported Supported
30 meters (98.5 feet)
Connecting the KVM series2-Adapter
1
to your unit
Choose an available port, labeled 1-16, on the rear of
your unit. Plug one end of a CAT 5 cable into a numbered
port and the other end into the RJ45 connector of a KVM
series2-Adapter module.
Fujitsu Technology Solutions GmbH, User Documentation, 33094 Paderborn, Germany
All hardware and software names used are trademarks of their respective manufacturers.
Quick Installation Guide
KVM series2-Adapter
KVM series2-Adapter
800x600
@ 85 Hz
Supported
Supported
Supported
Connecting a server to the KVM
2
series2-Adapter
Plug the KVM series2-Adapter module's VGA monitor,
keyboard and mouse connectors into the appropriate
port on the back of a server. Repeat this procedure for all
servers that are to be connected to the KVM series2 unit.
NOTE
: For use with Listed Information Technology
Equipment (I.T.E.).
installation
KVM series2-1602 Appliance
module - Sun
KVM series2-Adapter
module - USB
KVM series2-Adapter
module - PS/2
Power up your servers and KVM series2 unit. Ensure that
your unit is properly confi gured, then begin operation of
your system.
For additional information
For further information, please refer to the KVM series2
Installer/User Guide included with the unit. For the latest
software and fi rmware updates, check www.fujitsu.com.
Email - manuals@ts.fujitsu.com

2
CAT 5 cable -
up to 98.5 feet
(30 meters)
The KVM series2-Adapter-PS/2
can connect either a server or
a cascade switch to your KVM
series2-1602 unit
Powering up your system
3
Online - http://ts.fujitsu.com/support

590-341-609F