Werbung
Verfügbare Sprachen
Verfügbare Sprachen
HDA601
1.
Concentrator nozzle
2.
Handle
3.
Inlet filter
4.
Power switch
OPERATION
Connect the power cord to the the power supply.
Set the desired blowing level using the switch (4)
0 - Off
1 – Lower airflow level
2 – Higher airflow level
Set the desired blowing temperature using the temperature control (5)
0 – Cool shot
1 – Lower temperature
2 – Higher temperature
NOTE: If the cool shot button (6) is turned on, the cool shot mode is active regardless of the
temperature set with the temperature control (5)
After the completion of drying hair, disconnect the device from the power by removing the plug from
the socket.
CLEANING AND MAINTENANCE
Before cleaning, make sure that the dryer has been disconnected from the power supply.
The hair dryer housing may be wiped with a slightly damp cloth, then it should be immediately wiped
dry. Do not allow water to enter into the hair dryer.
It is recommended that dirt be removed from the inlet filter regularly as it can restrict the airflow.
You can remove the inlet filter by gently turning it according to the symbols printed on the hair dryer
housing and pulling it out.
5.
Temperature control
6.
Cool shot button
7.
Diffuser
5
Werbung
