RUSTA PATH LIGHT KENSINGTON Gebrauchsanweisung Seite 2

ENG
Thank you for choosing to
purchase a product from Rusta!
Path light Kensington, 3 W
Read the user manual carefully to make sure that the product is assembled, used and
maintained correctly, as described in the instructions in this user manual. Keep the user
manual for future reference.
CONTENT
• 1 path light Kensington, 3 W
• 1 ground spike
IMPORTANT!
Follow the instructions below to make sure that you install and use the product safely.
• You may only connect this product using other products from Rusta's lighting system
(Belys). To connect the light, you must use a Belys transformer or another Belys
product that is connected to the Belys system's transformer.
• The cable cannot be replaced, so if you damage the cable, you must throw the light away.
• Do not connect the light to the mains while it is still in the packaging.
• The LED light bulbs cannot be replaced.
• This light has been approved for outdoor use.
• The maximum load for the system is 24 W.
USE
• The light must be used outdoors.
• Clean the light with a soft, damp cloth.
• You cannot replace the LED light bulb and you must not touch it.
• The LED light bulb has a burning time of 20,000 hours.
ASSEMBLY
1. Screw the sections of the spotlight together.
2. Put the light into the ground. NOTE! Do not push the light into the ground. If the earth is
hard, we recommend softening it up before putting the light in. Check that the light is
firmly in place.
2
Read through the entire manual
before installation and use!