Installing Brackets On The Wall - bahag SUNFUN Betriebsanleitung

spirit level and chalk for marking (see fig.
C).
 Use chalk to mark the appropriate
locations on the wall by using the drilling
holes on the bottoms of the brackets.
 Use a 14mm masonry drill to drill the
appropriate holes at the markings for the
brackets.
 Make sure that the holes are 9 cm deep,
leading through solid bricks or concrete
(see fig. D). Don't drill through mortar
because it does not offer strong enough
support.
 Clean the dust from the holes by blowing
it out after drilling.
 Before inserting, loosen the bolt, washer
and clamping ring.
NOTE: It may be necessary to drive in
the anchor dowels with a wooden
hammer. Don't use a metal hammer
because it might damage the threads of
the anchor dowels.
 Tighten the anchor dowels and bolts with
a 17mm hexagon wrench. Use a
hexagon wrench with a closed end. This
way you avoid damaging the nuts (see
fig. E).

Remove the bolt completely (see fig. F).
Attention: If you notice that there is
no resistance when you pull the bolt
from the dowel, the anchor dowel
does not have enough anchorage.
Then you must repeat the complete
installation with a minimum offset of
15 cm! For correct mounting of the
anchor bolt, the dowel must be
inserted completely in the drilling
hole. It may not protrude from the
hole. If needed, remove the anchor
dowel and drill the hole deeper.
 Installing Brackets on the Wall
 Slightly fasten the brackets using the
bolts (see fig. F).
 Check their correct locations with a spirit
level.
Make sure that the brackets have been
installed tightly on the wall as soon as all
bolts have been inserted completely.
 Tighten the bolts again if the brackets
can still be moved.
 Make sure that the brackets have been
installed tightly
Mounting
on the wall.
9