Prog Button - US Blaster USB 7328 Betriebsanleitung

6. CONTINU / SINGLE BUTTON
Press these to switch between the SINGLE and CONTINUOUS play mode. The selected mode is
indicated on the LCD. In SINGLE mode, after each track, the unit stop the reading. In continu
mode, the unit read all track and stops.

7. PROG BUTTON

In STOP mode, you can program several tracks ( 20 tracks max. ) :
- Press the STOP button to enter in the stop mode
- Press the PROG button to enter in the program mode
- Use the skip track buttons to choose the track you want to listen then press the prog button to
enter you choice.
- Use one more time the skip track buttons to choose the track you want to listen then press the
prog button to enter you choice.
- Repeat the operation to select all the track you want to listen
- Press the play / pause button to start the playback
8. OUT BUTTON ( LOOP BUTTON )
When you press this button, you set the end point of the seamless loop and you start the loop. To
finish the loop, press again this button.
9. TRACK SELECT BUTTONS
Pressing 0-9 buttons, allow you to select tracks from the CD
10. RELOOP BUTTON ( LOOP SYSTEM )
This button is used to start the last saved loop. To finish the loop, press the reloop button.
11. SKIP I<< BUTTON
Use this switch to re-start the track or to select the last track.
12. CUE BUTTON
Pressing the CUE button during play provides a return to the position at which play was started
13. +10 BUTTON
Use this button to jump of 10 tracks in one press.
14. PLAY / PAUSE BUTTON
Each time you press the PLAY/PAUSE button, the operation changes from play to pause or from
pause to play.
15. SKIP >>I BUTTON
Used this knob to select the next track.
16. PITCH CONTROL
Use this fader to increase or decrease the speed of the track.
17. PITCH BEND + BUTTON
The pitch will automatically rise when the + button is pressed and return to the original pitch when
it is released.
18. PITCH BUTTON
If you push this button, the adjustement of the pitch potentiometer is available.
19. DISPLAY
20. PITCH BEND - BUTTON
The pitch will drop while the - button is pressed and return to the original pitch when it is released.
21. DISC-TRAY
To enter the disc, please refer to the explanations under 6.2 CD-tray
22. EJECT BUTTON
Press to load or eject disk. Each press will open or close the disk tray.
NOTE: disc holder will not open unless stop or pause button has been pushed fir
3