Phottix Strato TTL Benutzerhandbuch Seite 14

connected to the receivers on the same
channel will fire.
Please note:
- It is not unusual for the flash to discharge
once after turning on the Phottix Strato TTL.
- Flashes connect to Strato TTL receivers by
cable will have no TTL, HSS or SCS functions,
only simple triggering
Using the Strato TTL as a wireless
shutter release*
1. Turn off the camera and the Phottix Strato
TTL receiver.
2. Attach the correct Phottix Accessory Cable
for your camera make and model to the 2.5
14
mm Accessory Port on the Strato TTL receiver
3. Attach the other end of the cable to the
camera's remote port.
4. Turn on the camera and Phottix Strato TTL
receiver. Consult your camera manual for
specific settings for remote use.
5. Using the Phottix Strato TTL transmitter
will allow for remote wireless shutter release
functions. The Strato TTL shutter button
functions the same as a camera shutter
button: A half-press of the shutter button will
autofocus, a full press will take a photo.
Please Note:
When using the transmitter as a wireless
shutter release, pressing the shutter button
on the transmitter will only trigger cameras