AEG SNMP-PRO Kurzanleitung Seite 4

4. Access to the SNMP Adapter over the network
4.1. Add the route of the standard IP address on your computer
1.
Open the "DOS Command
2.
execute "cmd.exe"
3.
Enter the following command:
„route add 10.10.10.10 <local IP
(for example:
"route add 10.10.10.10 192.168.222.54" )
4.
Execute the command "ping 10.10.10.10" to check
if the device is reachable.
Advice: The SNMP Adapter needs approximately 30
seconds to start the webserver. If the webserver runs,
the LED will changes from red (booting) to green and
starts blinking.
5. Access via HTTP connection and login
1.
Start a Browser
2.
Enter the address http://10.10.10.10
3.
For the login choose the
user name: „admin"
Default password: „cs141-snmp"
6. Choose language
1.
Choose the entry
- System
- General
At the drop-down menu on the left side.
2.
Choose the preferred „Language".
Prompt" or
Address>"