Installation - Europalms Lightbox large 200 x 80 cm Bedienungsanleitung

Procedure:
Step 1: Carefully remove the protective foil and the poster/foil on one side of the
frame.
Step 2: Loosen the fixations screws the top
cover.
Step 3: Now pull out the back panel from the
groove of the side support.
Step 4: If replacing a defective tube, remove
the old tube first.
Step 5: Take off the receptacle from the tube.
Step 6: Replace the fluorescent tube.
Step 7: Refit the receptacle.
Step 8: Refit the back panel and the top cover.
Step 9: Tighten the screws.

Installation

This device is constructed for a standing installation only.
Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
The device must only be installed absolutely planar at a vibration-free, oscilation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1: On the baseplate, there are the holes for the installation.
Step 2: Hold the baseplate onto the location where the device is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes.
Step 5: Hold the baseplate in the desired position and tighten it.
Do not operate this device with opened cover!
Permanent installation is recommended!
11/12 00047094.DOC, Version 1.1