Led Controller - Kapego 846010 Bedienungsanleitung

Manual
Article No.: 846010

7. LED Controller

1. LED Controller - mounting instructions
To derive the heat, we recommend the installation to allow sufficient space for the air to circulate and the driver will not be overheated. Make
sure that all connections are tight. The signal line should be as far away from the power line (230V).
2. „Connect" Touch-Remote with LED Controller
1. Switch on the Power of the RF Controller and wait ca. 1s and then push the "ON" button on the Touch-Controller,
after that the LED flashes up 3 times, then the Touch-Controller and the Controller are connected.
2. If this step isn't working please try again.
3. „Disconnect" Touch-Remote with LED Controller
1. Switch on the LED stripe and wait ca. 1s and then hold the S+ button again till the stripe flashes up 9 times,
then the Touch-Controller and the bulb are disconnected.
2. Now you can address the stripe again with the same or another Touch-Controller.
4. Programs
1. Fade in Fade out
2. Strobe Warm White
3. Ramp up
4. Stribe Neutral White
5. Ramp down
Importer
6. Strobe Cold White
7. Random
8. Fade Color
9. Strope 3 Color
The product is CE compliant and meets all the essential requirements of Directive 1999/5/EC R&TTE.
The CE Declaration of Conformity for this product can be obtained at the following address.
http://deko-light.com/?page_id=4263
Auf der Hub 2
D-76307 Karlsbad
Tel.: +49 7248 / 92 71 500
Fax: +49 7248 / 92 71 550
7
Web: www.deko-light.com
Mail: deko@deko-light.com
13.09.2017