Installation:
•
Connect the speakers to the output terminal SPEAKER OUT.
•
Connect the car radio to the terminal POWER REM.
•
Connect the terminal POWER GND to the car chassis.
•
Connect the car battery to the terminal POWER +12V.
•
It is recommended to install the power supply cables and the audio cables on different sides of the car.
Input Sensitivity [GAIN]:
To adapt the amplifier to the car radio turn the volume control of the radio into the central position and adjust
the input sensitivities of the amplifier that the radio has a convenient volume. These adjustments provide a
sufficient power and an optimal Signal/Noise-Ratio.
Modes of Operation:
1. 5-Channel mode for connecting four speakers and a subwoofer:
Connect two speakers to the FRONT terminal, two speakers to the REAR terminal and the subwoofer to the
WOOFER terminal of SPEAKER OUT.
E.T.T. Electronic Toys Trading GmbH Kreuzstraße 65/66 38118 Braunschweig
Nachdruck oder Vervielfältigung nur mit ausdrücklicher Genehmigung
751-017