SEVERIN BP 2427 Gebrauchsanweisung Seite 7

- after use,
- in case of any malfunction, and also
- before cleaning the appliance.
●
When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
●
The appliance is not intended to be
operated by means of an external timer
or separate remote-control system
●
No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
●
This appliance is only intended for
domestic use and not for commercial
applications.
●
In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel. If repairs are
needed, please send the appliance to one
of our customer service departments.
The address can be found in the
appendix to this manual.
Before first use
Before the frying-pan is used for the first
time, the inner pan must be cleaned
according to the instructions in the section
General Care and Cleaning, and the knob
must be fitted to the top of the glass lid as
described below.
- Place the silicone insert (5) in the hole in
the glass lid (4).
- Place the knob (2) with spacer (3) onto
the glass lid (4).
- Insert the screw (7) with the washer (6)
into the hole in the lid (4).
- Tighten the screw (7) with a suitable
screw-driver.
Operation
- Apply a light coat of suitable fat or oil to
the surface of the pan.
- Make sure to fit the plug-in adapter to
the connection point first. Then insert the
plug into a suitable wall outlet and use
the temperature control to select the
desired temperature level.
- Allow the frying pan to pre-heat for
several minutes with the glass lid in place.
The indicator lamp switches off once the
pre-set temperature level is reached.
- Place the food to be fried into the pan,
but make sure that it is not over full.
- With the
temperature control, the temperature
can be adjusted during the cooking
process.
- Do not use sharp or pointed utensils
when turning the food over or lifting it
out. Do not sprinkle sugar directly into
the pan, to prevent the non-stick coating
from being damaged as a result of burnt-
in sugar.
- After cooking is complete, set the
temperature control to position '•' and
remove the plug from the wall outlet.
●
The temperature sensor in the plug-in
adapter reaches the same high
temperatures during operation as the pan
itself. It is therefore necessary to allow
sufficient time for the unit to cool down
before removing the plug-in adapter
from the connection point.
General care and cleaning
●
Allow the appliance to cool down
completely.
●
Before cleaning, ensure that the
appliance is disconnected from the power
supply. Only then remove the plug-in
adapter from the connection point.
●
To avoid the risk of electric shock, do not
clean the power cord and the plug-in
adapter with water and do not immerse
them in water.
●
To protect the housing and the non-stick
coating from damage, do not use metallic
pads, abrasives or harsh cleaning
solutions.
- To clean the plug-in adapter, use only a
soft, slightly damp lint-free cloth.
- The inner pan can be lifted out for
cleaning. A recess in the housing
facilitates removing the inner pan.
- The housing exterior, the glass lid and the
5
infinitely adjustable