Operation - Kalorik Exclusiv EXC SFC 1 Gebrauchsanleitung

Fax +32 2 359 95 50

OPERATION:

CAUTION! This appliance should not be used directly on soft plastics, non-pretreated wood or
cold glass.
Steam could damage the furniture surface. For a safe work please execute a test
run beforehand. Pay attention to the instructions for maintenance of the
manufacturer.
ASSEMBLY:
(DO NOT ATTACH THE APPLIANCE TO THE POWER SUPPLY UNTIL YOU HAVE CHOSEN AND
ATTACHED AN ACCESSORY.)
Warning! After use, unplug the appliance from the mains supply socket and press the steam
button to reduce the internal pressure sufficiently. Then you can release the safety lid.
1. Unscrew the safety lid. To do so, press the safety lid and at the same time turn it
anticlockwise (if there is still water in the tank and if the safety lid was still screwed in tight
for a previous use, some degassing will occur. This is normal and not dangerous).
2. Fill the water tank with water. Please use the provided measuring cup and the funnel. (It is
recommended that you fill the tank to max. 2/3 full.)
3. Note: never fill descaling agent, perfume or detergent into the water tank, in order to
avoid damages to the appliance.
4. Screw back the safety lid. To do so, press the safety lid and at the same time turn it
clockwise.
5. Put the desired accessory (flexible hose, nozzle, scrubbing brush etc.) on the appliance:
set the accessory on the connection in such a way that the opened padlock
accessory is well aligned with the arrow on the appliance, then press the accessory up to
the rubber sealing and turn the accessory in the direction indicated by the arrow on the
accessory until the accessory is locked to the appliance (and the closed padlock
the accessory is well aligned with the arrow of the appliance).
Flexible
hose
Nozzle
6. The brush and the curved nozzle can be assembled onto the connection, but also onto
the flexible hose or onto the straight nozzle.
Brush
Curved nozzle
7. Window wiper: Caution! Do not operate this appliance directly on cold glass.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Scrubbing
brush
Connection
11
Assembly page 11/60
on the
Connection
Sealing
EXC SFC 1 - 110310
of