Inverter 75068 Installations- Und Benutzerhandbuch Seite 13

BE机
Size(mm)
Model
※ Above data is subject to modification without notice.
2.2.2. Heat pump installation.
① The frame must be fixed by bolts (M10) to concrete foundation or brackets. The
concrete foundation must be solid; the bracket must be strong enough and anti-rust
treated;
② The heat pump needs a water pump (Supplied by the user). The recommended pump
specification-flux: refer to Technical Parameter, Max. lift ≥10m
③ When the heat pump is running, there will be condensation water discharged from the
bottom, please pay attention to it. Please insert the drainage tube(accessory) into the
hole and clip it well, then connect a pipe to drain off the condensation water.
2.2.3. Wiring & protecting devices and cable specification
① Connect to appropriate power supply, the voltage should comply with the rated voltage
of the products.
② Well earth the heat pump.
③ Wiring must be connected by a professional technician according to the circuit diagram.
④ Set breaker or fuse according to the local code (leakage operating current ≤ 30mA).
⑤ The layout of power cable and signal cable should be orderly and not affecting each
other.
Name
A
7300271 315
7300272 315
315
75067
74787 315
74788 395
75074 395
395
75068
75069 505
B C D
590 312 340
590 312 340
590 312 340
590 312 340
590 392 420
590 392 420
720 392 420
790 496 530
- 10 -
For installers and professionals
E F G
961 250 74
961 280 74
961 340 74
961 340 74
961 390 74
961 460 74
1092 620 74
1161 650 74
H
658
658
658
658
658
758
958
958