Seite 2
Clearaudio in our factory in Erlangen, Germany. The circuitry of the absolute phono is designed to work perfectly with any moving coil cartridge from any manufacturer. This is ensured due to the sophisticated current amplification circuit which eliminates the need to set the correct load resistance and load capacitance.
Seite 3
User manual / Bedienungsanleitung 1. Installation and set-up Before you begin, make sure that the tonearm is correctly installed on your turntable and is equip- absolute phono ped with the Clearaudio headshell and Clearaudio Direct Silver Wire with the special 9–pin connector.
Seite 4
To return to normal operation, tap the button again, now the LED ring will glow steadily. To switch the absolute phono off, press the button a little longer. At first the LED ring flashes quickly and then slower until it expires.
Seite 5
In case of any repair, the Clearaudio equipment needs to be send to your nearest authorized dea- ler or distributor. Only if your dealer or distributor cannot support you please contact Clearaudio direct: Clearaudio electronic GmbH Spardorfer Str. 150 91054 Erlangen...
Seite 6
5 years* * Provided that the warranty card is correctly completed and returned to Clearaudio within 14 days of purchase. Clearaudio electronic is not responsible for typographical errors in descriptions. Technical specifications subject to change or improvement without prior notice.
Seite 7
User manual / Bedienungsanleitung Sehr geehrte clearaudio-Kundin, sehr geehrter clearaudio-Kunde, absolute phono präsentiert clearaudio die weltweit erste Aktivlösung für alle Moving-Coil- Tonabnehmer (MC). Durch die Verstärkung des Schallplattensignals direkt an der Quelle, also am Tonabnehmer, mit Hilfe einer Platine, verbessert sich das Rauschverhältnis (Signal-to-Noise-Ratio) im gesamten Audiobereich um rund zehn Dezibel.
Seite 8
Verbinden Sie das mitgelieferte Netzteil mit der DC – Buchse (DC in 6V) und verbinden diesen erst danach mit dem Netzanschluss. Verbinden Sie die absolute phono mit dem Stromnetz und schalten Sie den Schalter auf „I“. Wichtig: Bitte beachten Sie, dass Sie nur Netzteile mit einer Spannung von 6V DC verwenden dürfen!
Seite 9
Betätigen Sie nun den an der Vorderseite befindlichen Taster mit einem leichten Druck. Der blaue LED-Ring fängt hierbei das Blinken an (ca. 7mal) und leuchtet anschließend dauerhaft blau. absolute phono Die clearaudio ist nun spielbereit. 1.1. Mute – und On / Off – Modus Um in den Mute-Modus zu gelangen, tippen Sie den Fronttaster einmal kurz an.
Seite 11
* Nur bei korrekt ausgefüllter und eingesandter Garantiekarte an clearaudio innerhalb von 14 Tagen. Änderungen bleiben vorbehalten. Lieferbar solange Vorrat reicht. Für Druckfehler keine Haftung. Irrtümer vorbehalten- Kopien und Abdrucke – auch nur auszugsweise – bedürfen der schriftlichen Genehmigung durch die clearaudio electronic GmbH. Made in Germany...
Seite 13
User manual / Bedienungsanleitung ITALIANO GARANZIA L’apparecchio è coperto da una garanzia di buon funzionamento della durata di un anno, o del periodo previsto dalla legge, a partire dalla data di acquisto comprovata da un documento attestante il nominativo del Rivenditore e la data di vendita.