RUSTA HASSLÖ Gebrauchsanweisung Seite 3

USING THE LIGHT FOR THE FIRST TIME
Even if the battery has been fully charged by the manufacturer, you should charge the
light for one day before using it for the first time. Remove the plastic strip that protects
the battery. Then place the light in direct sunlight for 6-8 hours to charge the rechargeable
battery before using it for the first time. The light will come on automatically when it gets
dark. It can take up to 4 days before the light starts to shine at its brightest. If the light
does not come on automatically at night, even after being in sunlight for 6 hours, check
the following:
- that the battery is in contact with the poles and that the + and - poles are correctly aligned.
- that the light is in a sunny location and that the panel itself faces the sun.
ASSEMBLY
The light must be assembled before it is installed.
1. Attach the lantern (B) to the lid (A).
2. Turn the lid (A) clockwise until the lid locks into place.
3. Attach the centre posts (C1+ C2) to the lantern (B).
4. Put these parts onto a flat surface. Mark the places where you
are going to drill the holes on the base of the centre post. Drill a
hole at each point that you have marked, making sure that
the plastic plugs (D) that are included can fit inside.
5. Press the plastic plugs (D) into the holes.
6. Screw in the screws (E) that are included. Make sure the screws
are properly tightened.
7. Attach the ground spike (F) to the centre post (C) and push the
ground spike into the earth. Loosen up the soil if the earth is solid.
USE
• You use the light outdoors for lighting gardens, patios, etc.
• Extend the life of the light and reduce the risk of rust. Keep the
light away from any areas that are too damp or too close to salt or
fertiliser.
• The solar panel must not be scratched, dusty or dirty. Clean the light
with a soft, damp cloth.
A
B
C1
C2
E
D
F
3