Replacing The Fuse; Technical Specifications - TechGrow T-Mini CO2 Bedienungsanleitung

Replacing the fuse:

If a short circuit occurs by overload of the fan(s),
the fuse will blow. The fuse is placed at the
bottom of the controller, left of the socket.
By pressing the fuse holder slightly with a
screwdriver and turning it counter-clockwise a
quarter turn, the fuse holder can be removed.
Place a new fuse with similar specifi cations in the
fuse holder and put the fuse holder back into the
casing.
Then press the fuse back in slightly, and tighten it
again with a clockwise quarter turn.
Damage caused by using the wrong fuse is not
covered by the manufacturer's guarantee.

TECHNICAL SPECIFICATIONS:

Power supply:
Consumption:
Adjustment range CO2 set:
Adjustment range CO2 +/-:
(hysteresis/bandwith)
Measurement time:
100 to 240 Volt
3 Watt (with sensor, without CO2-source)
200 to 2000 ppm
10 to 200 ppm (advice 50 ppm)
1 measurement per second