Button Control - TaoTronics Hello TT-SL038 Handbuch

Controller
• Input: 6V
• Standby Power Consumption: < 1W
• Maximum Working Current: 6A
• Power: <30W
• Working Temperature: -20 to 60°C / -4 to 140°F
• Weight: 50 g / 1.76 oz
• Dimensions: 5.0 x 3.5 x 2.2 cm / 2.0 x 1.4 x 0.9 in

Button Control

②
100 50
90 40
③
80 30
70 20
60 10
Button Operation Controls
①. ON / OFF Turns the string light ON / OFF
②. Increase / Adjusts the ash speed in ash /
Decrease Button smooth mode.
①
OFF ON
④
Clear
Smooth
1HZ
20S
Flash Smooth
2HZ ⑤
15S
Flash Smooth
3HZ
10S
Flash Smooth
5S
FF
Smooth
⑥
Adjusts the brightness level from least
③. Brightness Setting
bright (10) to most bright (100).
Clears the current mode and return
④. Clear Button
to 100% brightness.
⑤. Smooth Mode The light gradually fades in and out.
The light ashes at a constant speed
⑥. Flash Mode and can be changed between 1 Hz,
2 Hz, 3 Hz. FF means fast ashes.
Note: This string light includes a memory function. It will remember your
last setting when turned on.
FAQ
Q: Can I plug one string into the end of another string?
A: No, you cannot connect the strings end to end.
Q: The lights are not working.
A: Please make sure the lights are connected correctly and the input
power is correct.
Q: I have chosen ash / smooth mode, but the lights are not changing.
A: It is possible that the change speed is too slow. Press the up and
down button to change the ash / smooth speed.
Q: How can I change the brightness level under fade / smooth mode?
A: To adjust the brightness level in a particular mode:
• Clear the mode by pressing "Clear" button.
• Adjust the brightness level by pressing any one of the buttons with
number of 10, 20, 30 etc. to set your desired brightness.
• Select the mode you prefer by pressing the corresponding button.
Note: Brightness setting won't work if set after mode selection.
Set the brightness prior to selecting the mode.
03/04