Prevention Of Damage; Unpacking; Preparations; Installation - Tetra AquaArt LED Gebrauchsanleitung

English translation of the original German instructions

Prevention of damage

 Never transport the aquarium when it is filled.
 Only clean the aquarium with soft cloths or
sponges.
 For cleaning purposes, use clean water or special
cleaning products for aquaria.
Installing the equipment safely
 Install the aquarium on a level, waterproof and
stable surface.
 The load-bearing capability of the installation
location must be greater than the weight of the
aquarium when full. Information on the weight
when full can be found in the section entitled
Technical data
from page 15.

Unpacking

ATTENTION!
Damage to the aquarium cover and glass
breakage due to improper unpacking.
 Only lift the aquarium by the lower frame.
 Use a second person to help lift and
transport the aquarium.
 Open the packaging.
 Open the cover (Fig. A, 1).
 Remove the enclosed accessories and the
brochures from the aquarium.
 Store the accessories and the brochures in a
secure location.
 Close the cover.
 Tilt the packaging box slightly.
 Grip the aquarium by the lower frame.
 Carefully lift it out of the packaging.
 Place it down on a flat surface.
12

Preparations

ATTENTION!
Incorrect cleaning may damage the aquarium or
poison the tank contents.
 Never use any hard, pointed or sharp objects
for cleaning purposes.
 Use soft cloths or sponges.
 Use only clean water or special aquarium
cleaning products for cleaning purposes.
These are available from your stockist.
 Particularly the corners of the tank must be
cleaned carefully to prevent damage to the
glued joints of the glass walls.
 To check the aquarium for leaks, fill it with water.
 Fill the aquarium with clean water to cover the
vertical face of the top frame.
 Do not fill to the point that water flows over the
top of the frame.
 Leave the aquarium filled for 24 hours.
 Check whether there are any leaks.
 If the aquarium is leaking, empty it and exchange it
at your retailer.
 If it is not leaking, empty it and position it in its
permanent installation location.

Installation

ATTENTION!
Damage to the aquarium and glass breakage
due to improper transport.
 Empty the aquarium each time before it is
transported.
 Use a second person to help lift and
transport the aquarium.
 Lift the aquarium by the lower frame only.