Herunterladen Diese Seite drucken

Watts Water Technologies BT-PR02 RF Bedienungsanleitung Seite 5

Wireless plug mounting receiver

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 8
Install and plug the receiver into the following guidelines to guaranty an optimal reception:
-
The receiver must be put at a minimum distance of 50cm of all others electrical or wireless materials
like GSM, Wi-Fi router.
-
Before wiring work related to the receiver must be carried out only when de-energized
-
Connect your receiver to the power supply.
Following your installation an order of pairing must be respected for a correct RF initialisation.
Installation 1: Receiver + RF thermostat
1.
The receiver must be put in ON by pressing on the ON/OFF button.
2.
The receiver must be put in RF init mode by 5sec pressing on the RF Button.
3.
Then the RF LED should be Green fixed indicating that the Receiver is now in radio configuration mode
waiting for a thermostat configuration address.
Please refer to the thermostat leaflet for enter the thermostat in "RF Init" mode.
4.
5.
The receiver RF LED must be switched OFF and the thermostat should exit the RF init mode to indicate
correct paring between both elements.
Installation 2: Receiver + RF Thermostat + RF Central
Make the "Installation 1" rules for pairing with the thermostat.
1.
2.
The receiver must be put one time more in RF init mode by 5sec pressing on the RF Button.
3.
Then the RF LED should be Green fixed indicating that the Receiver is now in radio configuration mode
waiting for a thermostat configuration address.
Please refer to the Central leaflet for more explanation about the pairing mode "RF Init".
4.
5.
The receiver RF LED must be switched OFF and the Central will show a message to indicate correct paring
between both elements.
Installation 3: Receiver + RF Thermostat + RF Central + Slave receiver(s)
Make the "Installation 2" rules for pairing with the thermostat and the Central.
1.
2.
The Master receiver (receiver paired with the thermostat & Central) must be put in Receiver RF init mode by
10sec pressing on the RF Button.
3.
Then the RF LED should be Green/Red fixed indicating that the Receiver is now in radio configuration mode
waiting for a thermostat configuration address.
4.
Put now the Slave receiver in RF init mode by 5sec pressing on the RF button.
5.
The Master and Slave receiver RF LED must be switched OFF to indicate correct paring between both
elements.
6.
You can link up to 3 Slave receivers on a Master receiver, for this repeat the step 2 to 5 for each slave.
Note:
- The slave receiver will follow the working of Master receiver.
- Only receiver can be linked as slaves units (Max 3 slaves).
Installation 4: Receiver + Central
1.
The receiver must be put in RF init mode by 5sec pressing on the RF Button.
2.
Then the RF LED should be Green fixed indicating that the Receiver is now in radio configuration mode
waiting for a Central configuration address.
Please refer to the Central leaflet for more explanation about the pairing mode "RF Init".
3.
4.
The receiver RF LED must be switched OFF and the Central will show a message to indicate correct paring
between both elements.
Note:
- In this way the Receiver will works in Timer mode, you will have the possibility to create a weekly program
for ON/OFF period.
- You can also add 3 slaves receivers unit in this configuration.
Remarks:
-
In case of installation with BT-DP02 RF thermostat and loss RF communication (RF Alarm), the receiver will
follow 20% cycle of heating to prevent the installation against frost. (The receiver will stay in OFF mode if it
was in OFF before loss of RF communication).
5

Werbung

loading

Verwandte Produkte für Watts Water Technologies BT-PR02 RF