Making Ice Cubes; Main Switch; Stop Ice Cube Production - BOMANN EWB 1027 CB Bedienungsanleitung, Garantie

Making Ice Cubes

NOTE:
For hygienic reasons do not use the ice cubes
from the first cycle.
1. Connect the mains plug to the wall socket. Do
not turn on the ice maker within 120 minutes
after moving.
2. Open the lid and remove the ice cube
container.
3. Pour water into the water tank up to the
MAX-marking. Please use drinking water for
making ice.
CAUTION:
Only use drinking water without additives!
NOTE:
• The MAX marking is inside the water tank,
around the lower edge of the ice cube
container.
• The water level must be below the ice cube
container.
• Only use water at room temperature.
4. Replace the ice cube container and close
the lid
5. Press key to start making ice.
6. The process takes around 10 minutes.
7. Keep the lid closed.
NOTE:
• Depending on water/ambient temperature
the first ice cubes come out a bit smaller
• Due to fast freezing the ice cubes can look
milky. This is the air trapped in the water
and does not influence the quality of the ice
cubes.

Stop Ice Cube Production

Press key to stop Ice cube production
NOTE:
Before finally stopping the appliance
automatically empties the water tank and
dissolves already produced ice cubes.
38

Main switch

Press to start / stop the ice cube production
Press to resume making ice cubes after
adding water when water tank is empty; the
indicator lamp ADD WATER turns off.
Press to eliminating errors
Indicator Lamp ICE FULL
• The lamp indicates the ice storage box is full.
Remove all the ice cubes from the box.
• The low temperature protection (ambient
temperature is lower than 5ºC)
Indicator Lamp ADD WATER
The Indicator lamp turns on if the water tank is
nearly empty .The unit turns off automatically.
1. Open the lid and remove the ice cube box
2. Pour water into the water tank up to the
MAX-marking. Please use drinking water for
making ice.
3. Replace the ice cube container and close the
lid. Press key to start making ice.
Indicator Lamp WORK
• The indicator lamp starts flashing as soon as
unit was plugged into the wall socket.
• During operation indicator lamp illuminates
continuously.
CAUTION:
Wait at least 3 minutes before turning the
appliance on again, otherwise the compressor
can be damaged.
Cleaning
WARNING:
Always disconnect from mains power supply
before cleaning.
CAUTION:
• Do not use harsh or abrasive cleaning
agents.
• Do not use chemicals, acids, petrol or oil
products.
• Do not submerge the appliance in water.