Concox TR02 Bedienungsanleitung Seite 11

- Under the dash board below the front windshield;
- In the parcel shelf in the rear;
- In the front bumper (non-material face), make sure the device does not get wet;
- Under the wiper version (non-metal), make sure the device does not get wet;
- Non Covert Installation - fix the device on the dash board below windshield.
Device Wiring
1 The standard voltage is 9V-36V, the red wire is the positive, and the black wire is
the negative.
2. Connect the black wire to ground.
5. Quick Operation Instructions
， To properly use the device, common parameters should be set before initial
use. This can be done by using the parameter editor or by sending SMS
commands to the device. (","should be English comma and no space
before and after the comma)
5.1 Set APN
Change APN parameter by sending SMS command to the device as follows:
APN,666666,APN name# or APN,666666,APN name,user name,password#