Press the button connected with the channel to be
added (taught) to enter teach mode. The device
LED flashes orange. (Cancel by pressing the teach
button briefly, the device LED then turns red.)
If no teaching occurs, teach mode is automatically
ended after 20 seconds. If other devices are in teach
mode, these are taught.
If learning is completed successfully, it is indicated
with the flashing green LED (length of time depends
on whether it is still configuring).
Note: The four channels of the push-button
interface are added as toggle buttons.
Note: If the push-button interface is already
taught for a center and therefore is blocked
for direct training, it can still be put in teach mode
as described above, the device LED is illuminated in
red for 2 seconds after pressing an operating button
however. Direct teaching is not possible!
30