level one FSW-0508TX Startanleitung Seite 3

Connect Computer to the Switch
The UTP/STP ports support Auto-MDI/MDIX detecting
function, which gives true 'plug and play' capability. With
the Auto-MDI function, all you have to do is to plug-in the
network cable to the switch directly and no need to check if
the end node is NIC (Network Interface Card) or switches
and hubs. Located at the rear site of the Switch, RJ45 ports
are where you will connect your Computers to the Switch.
Power on the Switch
Connect the Switch's AC power adapter to the Switch's
Power port. Plug the other end of the adapter into an AC
outlet. When connected the AC power adapter to the switch's
Power port and AC outlet will immediately power on this
Switch.