Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
A. Food Pusher
B. Feed Chute
C. Fine Grating Cone
D. Thin Slicing Cone
E. Medium Grating Cone
F. Coarse Grating Cone
G. Thick Slicing Cone
H. Appliance Base (Motor Unit)
I. Handle
J. ON/OFF Switch
If you are using the kettle for the first time, it is recommended that you clean your kettle before use by
boiling a full kettle of water twice and then discarding the water.
Before First Use
Carefully unpack your appliance and remove all accessories. Wash them in warm, soapy water then rinse
and dry with a dry towel. Carefully wipe the exterior of the base if necessary. WARNING: Do not immerse
the appliance base in water or any other liquids.
Using the Electric Slicer & Grater
•
Attach the Feed Chute to the Appliance Base. This is done by holding the Feed Chute at a 45
degree angle to the right, inserting it in to the socket on the Appliance Base, then rotating it 45
degrees back to the left so that it is locked in to place in the upright position.
• Select a cone suitable for the slicing or grating task you require and fit it onto the star shaped
drive mechanism at the back of the Feed Chute. Rotate it slightly clockwise to hold it in place.
• Cut the ingredients into pieces that will fit into the Feed Chute and place a suitable container
under the outlet.
•
Connect the appliance to a suitable 220 -240V ~ 50Hz power outlet socket
•
Press the ON/OFF button once or twice to ensure that the Cone has locked into place and turns
freely.
•
Make sure that the Pusher has been removed from the Feed Chute, and then insert the pre-cut
food through the top of the Feed Chute.
•
Press and hold down the ON/OFF button to activate the motor then slowly push the food down
with the pusher. Do not exert too much pressure on the pusher, as this could affect the quality of
the end result and could even cause damage to the appliance.
• Turn off by releasing the ON/OFF button.
•
To remove the cone unlock the Feed Chute by rotating it 45 degrees to the right then lock it back
into place by rotating 45 degrees back to the left. The Cone can now be easily removed.
Overview
Before initial use
Operation
8
Werbung
Inhaltsverzeichnis
