Werbung
Please read this manual prior to
first use of the product resp. its
installation! This product must
only be used as required in this
manual.
The figure is designed for use
on model train layouts – exclu-
sively in dry areas.
Using the product for any other
purpose is not approved and
is considered incorrect. The
manufacturer cannot be held
responsible for any damage
resulting from the improper use
of this product; liability in such a
case rests with the user.
Installation and electrical wiring
may only be carried out while the
power supply is switched off.
Only use transformers compli-
ant with VDE / EN standards.
1. Introduction
The power supply should be be-
tween 14 and 16 V AC or DC.
2. Mounting
The figure can be installed in the
baseboard or inside a building. For
the installation of the drive you will
need a 12 mm diameter drill bit.
Insert the drive into the hole from
above until its upper flange rests on
the base.
Touch the model only at the
drive. Otherwise the figure may
be damaged due to handling.
The safety washer holds the drive in
place. Slide it upwards from below
until the model is fixed in position
without play (see fig. 3).
Make sure the arm can move freely.
Connect the brown and yellow wires
to the output terminals of your light-
ing transformer (e.g.: Viessmann
5200, see fig. 1). If you have a DC
power pack wire the brown cable to
the positive terminal, the yellow one
to the negative. If you want to be able
to switch the circuit on and off we
recommend the Viessmann univer-
sal on-off switch 5550 (see fig. 2).
3. Removal
If you want to remove the model from
the layout turn the safety washer on
the drive by 90º and pull it down-
wards. Only touch the model at the
drive!
Technische Daten
Betriebsspannung:
Höhe über Grundplatte: ca. 22 mm
Stromaufnahme:
Länge Antriebszylinder: 40 mm
Technical Data
Voltage:
Height above baseboard: appr. 22 mm
Current draw:
Length of drive:
GB
14 – 16 V =/~
ca. 100 mA
14 – 16 V =/~
appr.100 mA
40 mm
3
Werbung
