Operating Modes - AimTTi TG1006 Bedienungsanleitung

Specifications apply at 18°- 28°C after one hour warm-up, at maximum output into 50Ω.
WAVEFORMS
Standard waveforms of Sine, Square, Triangle and DC.
Sine
Range:
Resolution:
Accuracy:
Temperature Stability:
Output Level:
Harmonic Distortion:
Non−harmonic Spurii:
Square
Range:
Resolution:
Symmetry Control:
Accuracy:
Output Level:
Rise and Fall Times:
Aberrations:
Triangle
Range:
Resolution:
Accuracy:
Output Level:
Linearity Error:

OPERATING MODES

Continuous
Continuous cycles of the selected waveform are output at the programmed frequency.
Sweep
Carrier Waveforms:
Sweep Mode:
Sweep Width:
Sweep Time:
Sweep SYNC:
Sweep Trigger Source:
Manual Sweep Mode:
2
1mHz to 10MHz.
1mHz or 6 digits.
10 ppm for 1 year; ± 1mHz below 0.2Hz.
Typically <1 ppm/ºC outside 18° to 28°C.
1mV to 10Vp−p into 50Ω.
<0.3% THD to 20kHz (typically 0.1%).
<–45dBc to 300kHz.
<−30dBc to 10MHz (typically <−35dBc).
<–55dBc to 1MHz, <–55dBc + 6dB/octave 1MHz to 10MHz.
1mHz to 10MHz.
1mHz or 6 digits.
20% to 80%, 1mHz to 10MHz.
10 ppm for 1 year; ± 1mHz below 0.2Hz.
1mV to 10Vp−p into 50Ω.
<25ns.
<5% + 2mV.
1mHz to 1 MHz.
1mHz or 6 digits.
10 ppm for 1 year; ± 1mHz below 0.2Hz.
1mV to 10Vp−p into 50Ω.
<0.5% to 100 kHz.
All
Manual, linear or logarithmic, single or continuous.
From 0.1Hz to 10MHz in one range. Phase continuous. Independent
setting of the start and stop frequency.
100ms to 999.99s (10ms resolution).
Start of sweep trigger available from SYNC output.
The sweep may be free run or a single sweep may be triggered from the
front panel MAN TRIG key.
An analogue control can be used to set the generator to any intermediate
frequency between the Start and Stop frequencies.
Specifications