Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
1.) Mount the controller on the clear wall of the tank/sump.
2.) Connect the pump wire with the controller.
3.) Connect the hose with the pump. Mount the output tubing
Higher than the tank/sump and reservoir level to prevent
a siphon effect.
4.) Connect the power adapter with the controller jack and then
with a power source.
5.) Position it by moving the outside controller under the
present water level or 1/5 inch (5mm) higher than the present
water level to test the function.
Note
1.) Please read the user manual in detail before using.
2.) Keep the power adapter and jacks dry and away from water.
3.) Please clean the sensor if needed.
4.) Avoid installing controller in an area with bubbles
or direct light.
5.) The water tube output needs to be higher than the water
level in the tank/sump to avoid a siphon effect.
Werbung
