Taking The Appliance Out Of Service - Jupiter juicepresso 867200 Gebrauchsanleitung

Operating Instructions
Extracting juice
NOTE Risk of damage to the appliance!
• If the appliance malfunctions during the juicing process,
switch it off immediately (see section
ing) .
• Remove all hard stalks, shells, cores and stones before
juicing. These could block or damage the appliance.
• Only use the pusher A to push food down.
• Wash the food to be juiced thoroughly.
• Extract juice from the food in accordance with the sup-
plied recipe book .
• Fill the food to be juiced into the filling hopper
portion at a time.
• Push it down using the pusher
Excessive pushing will not speed up the process and
INFO:
will cause the drum to overflow.
After juicing approx. 1 kg of food, pour some water
TIP:
into the filling hopper to flush it out and switch on the
appliance.

Taking the appliance out of service

NOTE Risk of damage to the appliance!
Allow the appliance to empty completely before switch-
ing it off.
• Pour some water into the filling hopper to flush it out
and switch on the appliance.
• Switch the appliance off (on/off switch
• Plug out the mains plug.
• Clean the appliance thoroughly (see section
Cleaning
WARNING Risk of electric shock!
Unplug the appliance from the mains before cleaning.
NOTE Risk of damage to the appliance!
Always clean the appliance thoroughly
use to prevent damage and malfunctions.
Dishwasher can cause damage!
NOTE
The appliance components are not dishwasher-safe. Only
clean the components using lukewarm water and wash-
ing-up liquid.
• Disassemble the appliance before cleaning it (see sec-
tion
Assembly/disassembly
• Never immerse the motor unit in water and never hold
it under running water.
• Only clean the motor unit using a damp cloth.
• Only dry the components using a dry cloth. Do not dry
using heat!
8 Subject to technical changes without notice; no responsibility is accepted for the accuracy of this information.
Troubleshoot-
one
B
.
A
E is set to OFF ).
Cleaning ).
immediately after
).
Cleaning the drum
• Pull the yellow silicone seal on the underside of the
drum completely out of the pulp outlet slot.
• Clean the drum, pulp outlet and juice outlet thoroughly
and rinse them off under running water.
• Only dry the drum using a dry cloth. Do not dry using
heat!
• Press the seal back into the pulp outlet slot as far as
the marking line.
Cleaning the squeezing screw
• Pull off the two rubber pads inside the squeezing screw
in order to clean them.
• Clean both inside and outside of the squeezing screw
thoroughly using the supplied cleaning brush.
• Rinse the squeezing screw off thoroughly under running
water.
• Only dry the squeezing screw using a dry cloth. Do not
dry using heat!
• Re-insert the rubber pads.
Storage
Store the appliance in its original packaging, in a dry, dust-
free and cool place that is out of reach of children.