Operations; Power On/Off And Volume Adjustment; Transmission; Monitor - Midland G11V Bedienungsanleitung

Operations

Power on/off and volume adjustment

Rotate the Power/Volume knob clockwise to turn the radio on.
Rotate the control clockwise /counter-clockwise to adjust the volume le-
vel as you prefer.
Rotate the control counter-clockwise till hearing a mechanical "click", to
turn the radio off.

Transmission

To communicate, all radios in your group must be set to the same chan-
nel.
Briefly press the Function key 1 to enable the Monitor feature in order
to make sure that the frequency is not busy, then press the PTT button.
For a maximum clarity, hold the device at a distance of about 4/10 cm.
Release the PTT key to receive.
Only one user at a time can talk during radio communications. Therefore, it
is important not to transmit when you are receiving a communication and
use the transmission mode sparingly to allow other users to use the feature.
Transmission consumes a significant amount of energy and should therefore
be used sparingly to prolong the battery life.
If you are unable to contact a station that you have no problems in receiving,
the station may be using CTCSS tones or DCS codes.

Monitor

The Monitor feature is for temporarily excluding (opening) the Squelch,
in order to listen to signals that are too weak to keep the Squelch perma-
nently opened.
Briefly press the Function key 1 to enable such function.

Scan

Keep pressed the Function key 2 for about 4 sec. to enable the SCAN
function: the radio will scan all channels from the channel in use.
Whenever any signal is detected, the radio will suspend the Scan; to resu-
me scanning, press again the PTT button.
6 | Midland G11V instruction guide